Four Wheel Drive Selector Switch: Service and Repair

Removal Procedure
1. Remove the automatic transfer case switch from the instrument panel.
^ Pull the tabs on the rear of the switch in.
^ Pull the switch straight out from the panel. Remove the electrical connector from the automatic transfer case switch.

Installation Procedure
1. Install the electrical connector to the automatic transfer case switch.
2. Install the automatic transfer case switch into the instrument panel.
3. Ensure the automatic transfer case switch locks into the instrument panel.

Transfer Case Shift Control Module Replacement
Removal Procedure
1. Remove the nuts securing the automatic transfer case control module to the retainer.
2. Disconnect the two wiring harness connectors from the automatic transfer case control module.





3. Slide the automatic transfer case control module straight out from the retainer.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the automatic transfer case control module into the retainer with the nuts.
^ Tighten the nuts to 6 Nm (53 inch lbs.).
2. Connect the two wiring harness connectors to the automatic transfer case control module.
3. Start the engine and test the automatic transfer case system for proper shift operation.