SIR Steering Wheel Module Coil - Disassemble

1. Remove the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle (Column Shift) or Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle (Floor Shift).
2. Remove the wire harness assembly (1) from the steering column and the wire harness strap (2).
3. Disconnect the inflatable restraint steering wheel module coil connector from the turn signal switch assembly connector.





4. Remove the retaining ring (3) from the steering shaft assembly by using snap ring pliers.
5. Remove the inflatable restraint steering wheel module coil (2) from the steering shaft assembly.
6. Remove the wave washer (1) from the steering shaft assembly.