Sliding Door Lock Replacement

Sliding Door Lock Replacement

Removal Procedure

1. Remove the trim panel. Refer to Door Trim Panel Replacement (Service and Repair) .
2. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement (Service and Repair) .
3. Remove the upper access cover, if equipped.




4. Remove the lock rods (1) from the lock assembly (1 and 3).




5. Disconnect the electrical connector from the lock (5).
6. Remove the lock bolts (1).




7. Remove the lock from the door (2).



Installation Procedure





1. Install the lock to the door (2).

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the lock bolts (1).

Tighten the lock bolts to 9 N.m (80 lb in).





3. Connect the electrical connector (5) to the lock.




4. Install the lock rods (1 and 3).
5. Install the upper access cover, if equipped.
6. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement (Service and Repair) .
7. Install the trim panel. Refer to Sliding Rear Side Door Trim Panel Replacement (Service and Repair) .