Shift Lever

Removal Procedure





1. Remove the 2 TORX head screws from the lower trim cover.
2. Remove the lower trim cover.
3. Roll the shift lever boot back until the TORX head screw is exposed.
4. Remove the TORX head screw.
5. Remove the shift lever wiring from the retainer clips.
6. Remove the wiring from the electrical connector.
7. Remove the shift lever.

Installation Procedure
1. Install the shift lever.
2. Connect the wiring to the electrical connector.
3. Install the wiring on the retainer clips.

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the TORX screw.
Tighten the TORX head screw to 22 Nm (16 ft. lbs.).
5. Roll the shift lever boot over the TORX head screw.
6. Install the lower column cover.
7. Install the 2 TORX head screws to the lower column cover.
Tighten the screw to 3 Nm (25 inch lbs.).