Radio/Audio System Operation (RPO UM6)

TO PLAY A CASSETTE
The tape player is built to operate best with tapes that are 30-45 minutes of length per side. Tapes that are longer than 30-45 minutes are thin and may not work well in the player.
Use the following procedure in order to play a cassette:
1. Turn the lock cylinder to the ACCESSORY or to the RUN position.
2. Turn the receiver ON.
3. End-load the tape into the player. This is accomplished by inserting the tape squarely through the door.

Ensure that the exposed tape side of the cassette faces the right.

4. Verify that the tape is fully inserted.

The AM/FM portion of the radio turns off and the tape begins playing when fully inserted.

5. Use the upper and the lower knobs in order to adjust the volume, the balance, and the fade (just as with the radio).

An arrow indicates which side of the tape is being played.

6. Press SEEK UP in order to fast forward the tape. The tape will rapidly advance until you press the SEEK UP pushbutton again.
7. Press SEEK DOWN in order to rewind the tape. The tape will rewind rapidly until you press the SEEK DOWN pushbutton again.
8. Press the upper knob in order to go from one side of the tape to the other.
9. Press the EJECT pushbutton in order to stop the tape or to remove the tape from the player.

For a description of the RPO Code(s) shown in this article/images refer to the RPO Code List found at Vehicle/Application ID Application and ID