Wheel Hub Bolt Replacement

FRONT WHEEL BEARINGS/HUB

Removal Procedure

Tools Required
^ J 6627-A Tie Rod Puller

1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and the wheel.

Notice: Support the caliper with a piece of wire to prevent damage to the brake line.

3. Remove the brake caliper.

Important: Do not hammer on a wheel bolt.





4. Remove the hub bolt using the J 6627-A.

Installation Procedure
1. Install the hub bolt to the hub and bearing assembly.

Notice: Refer to Fastener Notice in Service Precautions.





2. Install four washers and the nut to the bolt.
2.1. Tighten the nut. Draw in the bolt.
2.2. Remove the nut and the washers.
3. Install the brake caliper.
4. Install the tire and the wheel.
5. Lower the vehicle.