Fuel Tank Pump Module Replacement

REMOVAL PROCEDURE

TOOLS REQUIRED
^ J34730-1A Fuel Pressure Gauge
^ J 39765 Fuel Sender Lock Nut Wrench

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
4. Remove the fuel tank.
5. Remove the fuel sender assembly.




6. Note the position of the fuel strainer (2) on the fuel sender.
7. Support the fuel sender assembly with one hand and grasp the strainer (2) with the other hand.
8. Pull the strainer off the fuel sender. Discard the strainer after inspection.
9. Inspect and clean the fuel tank if needed. Refer to Fuel System Cleaning.
10. Disconnect the fuel pump electrical connector (5).
11. Remove the fuel level sensor electrical connector retaining clip (6).
12. Disconnect the fuel level sensor electrical connector (7) from under the fuel sender cover.
13. Remove the fuel level sensor retaining clip (4).
14. Squeeze the locking tangs and remove the fuel level sensor (3).
15. Remove the fuel pressure sensor (1).

INSTALLATION PROCEDURE




1. Install the fuel pressure sensor (1).
2. Install the fuel level sensor (3).
3. Install the fuel level sensor retaining clip (4).
4. Connect the fuel level sensor electrical connector (7).
5. Connect the fuel level sensor electrical connector retaining clip (6).

IMPORTANT: Always install a new fuel strainer when replacing the fuel tank fuel pump module.

6. Connect the fuel pump electrical connector (5).
7. Install a new fuel strainer (2) in the same position as noted during disassembly. Push the strainer on the bottom of the fuel sender until the strainer is fully seated.




8. Install the fuel sender assembly.
9. Install the fuel tank.
10. Refill the fuel tank.
11. Install the fuel filler cap.
12. Connect the negative battery cable.
13. Inspect for a fuel leak.
13.1. Turn ON the ignition switch for 2 seconds.
13.2. Turn OFF the ignition switch for 10 seconds.
13.3. Turn ON the ignition switch.
13.4. Inspect for fuel leaks.