83. Throttle Body Installation - With RPO 9C2

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the throttle body studs, if removed.
^ Tighten the studs to 12 Nm (18 ft. lbs.).
2. Install the throttle body gasket.





3. Install the throttle body onto the manifold.





4. Install the throttle position bracket for the governor.





5. Align the slot in the throttle position bracket for the governor with the throttle body pin.





6. Ensure correct placement of the slot in the throttle position bracket for the governor with the pin on the throttle body.





7. Install the throttle body nuts.
^ Tighten the nuts to 10 Nm (89 inch lbs.).