Ignition & Key Alarm Switch - Disassemble

1. Remove the upper and lower trim covers. Refer to Trim Covers, Shim Lever Seal - Disassemble - Off Vehicle.





2. Remove the wire harness assembly (1) from the wire harness strap (2).
3. Remove and dispose of the smaller wire harness straps.





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





5. Remove the key alarm connector (1) from the electronic lock module assembly (2).
5.1. Rotate the key alarm connector (1) 90 degrees.
5.2. Pull the key alarm connector (1) out of the electronic lock module assembly (2).





6. Remove the 2 tapping screws (2) from the ignition and key alarm switch assembly (1).
7. Remove the ignition and key alarm switch assembly (1) from the electronic lock module assembly.
1. Remove the upper and lower trim covers. Refer to Trim Covers, Shim Lever Seal - Disassemble - Off Vehicle.





2. Remove the wire harness assembly (1) from the wire harness strap (2).
3. Remove and dispose of the smaller wire harness straps.





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





5. Remove the key alarm connector (1) from the electronic lock module assembly (2).
5.1. Rotate the key alarm connector (1) 90 degrees.
5.2. Pull the key alarm connector (1) out of the electronic lock module assembly (2).





6. Remove the 2 tapping screws (2) from the ignition and key alarm switch assembly (1).
7. Remove the ignition and key alarm switch assembly (1) from the electronic lock module assembly.