SIR Steering Wheel Module Coil - Assemble

1. The block tooth on the steering shaft assembly (1) must be in the 12 o'clock position.





2. Install the wave washer (1) onto the steering shaft assembly (2).

Important: A new inflatable restraint steering wheel module coil is pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.





3. If installing the existing inflatable restraint steering wheel module coil it must be centered first. Refer to Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle.
4. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
5. Slide the new inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
6. Firmly seat the new retaining ring (3) into the groove on the steering shaft assembly (2).
7. Remove the centering tab from the new inflatable restraint steering wheel module coil (4).
8. Discard the centering tab.





9. Attach new wire harness straps to the wire harness assembly (1).
10. Attach the wire harness assembly (1) to the wire harness strap (2).
11. Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle.