Ignition & Key Alarm Switch - Assemble

1. Install the ignition and key alarm switch assembly (1) onto the electronic lock module assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the 2 tapping screws (2) into the ignition and key alarm switch assembly (1).
Tighten the 2 tapping screws to 1.5 Nm (13 inch lbs.).





3. Install the key alarm connector (1) into the electronic lock module assembly (2).
3.1. Push the key alarm connector (1) into the electronic lock module assembly (2).
3.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





5. Attach new wire harness straps to the wire harness assembly (1).
6. Install the wire harness (1) to the wire harness strap (2).
7. Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Sea/ - Assemble - Off Vehicle.