Turn Signal & Multifunction Switch - Disassemble

1. Remove the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle.
2. Remove the wire harness assembly (1) from the wire harness strap (2).
3. Remove and dispose of the small wire harness
straps from the wire harness assembly (1).





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





5. Remove the 2 pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
6. Remove the turn signal and multifunction switch assembly (2) from the steering column housing assembly.