Turn Signal & Multifunction Switch - Assemble

1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
2. Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.

Notice: Refer to Fastener Notice in Service Precautions.

3. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).
Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





5. Attach new wire harness straps to the wire harness assembly (1).
6. Attach the wire harness assembly (1) to the wire harness strap (2).
7. Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle.