Turn Signal Cancel Cam & Bearing Thrust Washer - Assemble

- Tools Required
- J23653-SIR Lock Plate Compressor
- J42137 Lock Plate Compressor Adapter





1. Install the following parts onto the steering shaft assembly:
1.1. The thrust washer (1).
1.2. The upper bearing spring (2).
1.3. Lubricate the turn signal cancel cam assembly with lithium grease.
1.4. The turn signal cancel cam assembly (3).
1.5. The shaft lock shield assembly (4).





2. Compress the shaft lock shield assembly (2) using J23653-SIR and J42137.
3. Install the new bearing retainer (1) onto the steering shaft assembly.
4. Firmly seat the bearing retainer (1) into the groove on the steering shaft assembly.
5. Remove J23653-SIR and J42137 from the steering shaft assembly.
6. Install the inflatable restraint steering wheel module coil assembly. Refer to Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle.