Fog Lamp Replacement - Front (Z71)

REMOVAL PROCEDURE

CAUTION: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:
- Turn off the lamp switch and allow the bulb to cool before changing the bulb.
- Leave the lamp switch OFF until the bulb change is complete.
- Always wear eye protection when changing a halogen bulb.
- Handle the bulb only by its base. Avoid touching the glass.
- Keep dirt and moisture off the bulb.
- Properly dispose of the used bulb.
- Keep halogen bulbs out of the reach of children.




1. Disconnect the electrical connector from the fog lamp.




2. Remove the nuts from the fog lamp.




3. Remove the fog lamp from the front bumper fascia.




4. Remove the fog lamp bulb from the fog lamp, turning counterclockwise, if required.

INSTALLATION PROCEDURE




1. Install the fog lamp bulb to the fog lamp, turning clockwise, if required.




2. Install the fog lamp to the front bumper fascia.

NOTE: Refer to Fastener Notice in Service Precautions.




3. Install the nuts to the fog lamp.

Tighten
Tighten the fog lamp to 2 N.m (18 lb in).




4. Connect the electrical connector to the fog lamp.

"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID". RPO Codes