Electronic Column Lock Module - Disassemble

1. Remove the turn signal cancel cam, bearing thrust washer. Refer to Turn Signal Cancel Cam, Bearing Thrust Washer- Disassemble - Off Vehicle.
2. Remove the park lock cable assembly (1) from the electronic lock module assembly.
2.1. Place the steering column lock cylinder set into the OFF position.
2.2. Place the shift lever clevis into the PARK position.
2.3. Use a small blade to push against the locking tab on the end of the park lock cable assembly (1).
2.4. Disconnect the park lock cable assembly (1) from the electronic lock module assembly.





3. Rotate the key alarm connector (1) 90 degrees'
4. Pull the key alarm connector (1) out of the electronic lock module assembly (2).
5. Remove the passkey connector from the electronic lock module assembly (2).





6. Insert J 42759 into the electronic lock module (1) and slide the ignition and key alarm switch assembly (2) out.
7. Let the ignition and key alarm switch assembly (2) hang freely.





8. Remove the 3 pan head tapping screws (1) from the electronic lock module assembly (2).
9. Remove the electronic lock module assembly (2) from the steering column housing assembly (3).