Turn Signal Cancel Cam & Bearing Thrust Washer - Assemble

- Tools Required
- J 23653-SIR Lock Plate Compressor





1. Install the following parts onto the steering shaft assembly:
- The thrust washer (1).
- The upper bearing spring (2).
- Lubricate the turn signal cancel cam assembly (3) with lithium grease.
- The turn signal cancel cam assembly (3).
- The cam orientation plate (4).





2. Compress the cam orientation plate using J 23653-SIR.
3. Install the new bearing retainer onto the steering shaft assembly.
4. Firmly seat the bearing retainer into the groove on the steering shaft assembly. Remove J23653-SIR. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle.