Turn Signal & Multifunction Switch - Disassemble - Export

1. Remove the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle.
2. Remove the wire harness assembly (1) from the wire harness strap (2) and the steering column.
3. Disconnect the turn signal and multifunction switch assembly connector from the inflatable restraint steering wheel module coil connector.





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





5. Remove the 2 pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
6. Remove the turn signal and multifunction switch assembly (2) from the steering column housing assembly.