Shift Lever - Assemble

1. Install the shift lever seal (2) onto the shift lever assembly (4).

Important: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The electronic lock module assembly wires and connector must be hanging out of the middle of the abrasion sleeve.

2. Install the shift lever assembly (4).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the shift lever screw (3) into the shift lever assembly (4).
- Tighten the shift lever screw to 1.5 Nm (13 inch lbs.).
4. Slide the shift lever seal (2) down the shift lever assembly (4).
5. Install the upper and lower shrouds. Refer to Steering Column Trim Covers - Assemble - Off Vehicle.