Front Position Sensor Link Assembly Replacement

^ Tools Required
- J 38185 Spring Hose Clamp Pliers

Removal Procedure

Important: Do not attempt to pry the link rod from the real time damping (RTD) ball stud. If the link rod needs to be replaced or disconnected you must use the following procedure.





1. Remove the RTD sensor from the vehicle. Refer to Front Position Sensor Replacement - Electronic Suspension.
2. While supporting the sensor lever by hand, twist the link rod to remove it from the ball stud.
3. Remove the link rod from the mounting bracket ball stud.


Installation Procedure
1. Using the J 38185 install to link rod to the ball stud on the sensor lever and the mounting bracket.
2. Install the RTD sensor to the vehicle. Refer to Front Position Sensor Replacement - Electronic Suspension.