Blower Motor: Service and Repair
BLOWER MOTOR REPLACEMENTREMOVAL PROCEDURE
1. Remove the instrument panel compartment.
2. Remove the front screw from the right door sill plate.
3. Remove the right hinge pillar trim panel.
4. Disconnect the electrical connectors to the Powertrain Control Module (PCM), as necessary. Remove the PCM and the mounting bracket.
5. Remove the blower motor cover.
6. Disconnect the electrical connectors from the blower motor (5), as necessary.
7. Remove the bolt from the right lower instrument panel support.
8. Remove the blower motor cooling tube.
9. Remove the blower motor flange screws (4).
10. Complete the following steps in order to remove the blower motor:
- Carefully pull forward the blower motor in order to avoid distorting the blower fan.
- Pry back the right side of the instrument panel, as necessary.
11. Complete the following inspection steps:
- Inspect the blower motor terminals for distortion.
Clean any corrosion from the terminals, or replace the blower motor as necessary.
- Inspect the flange of the blower motor for any damage or distortion that may cause an air leak.
Repair the flange, as necessary.
- Inspect the blower fan for any damage or distortion.
INSTALLATION PROCEDURE
1. Guide the blower motor (5) and the blower fan into position in order to install the blower motor.
Use care in order to avoid catching the blower fan on any protruding parts.
2. Install the blower motor flange screws (4).
3. Install the blower motor cooling tube.
4. Connect the electrical connectors, as necessary.
5. Install the blower motor cover.
6. Install the bolt to the right lower instrument panel support.
7. Install the mounting bracket and the Engine Control Module (ECM).
8. Connect the electrical connectors to the ECM, as necessary.
9. Install the right hinge pillar trim panel.
10. Install the front screw into the front door sill plate.
11. Install the instrument panel compartment.