Oil Pressure Sensor: Service and Repair

ENGINE OIL PRESSURE SENSOR OR SWITCH REPLACEMENT

TOOLS REQUIRED
J 41712 Oil Pressure Sending Unit Socket

REMOVAL PROCEDURE




1. Remove the engine cover from the engine block.
2. Remove the fuel filter/water separator from the lower intake manifold and position to the side.
3. Remove the electrical connector from the oil pressure sending unit.




4. Use the J 41712 to remove the oil pressure sending unit from the engine block.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Use the J 41712 to install the oil pressure sending unit to the engine block.

Tighten
Tighten the oil pressure sending unit to 12 N.m (9 lb ft).

2. Install the electrical connector to the oil pressure sending unit.




3. Install the fuel filter/water separator to the lower intake manifold.
4. Install the engine cover to the engine block