Headlamp: Service and Repair

REMOVAL PROCEDURE




1. Make sure the headlamp switch is in the OFF position.
2. Remove the retaining ring screws (5) from the retaining ring (4).
3. Remove the retaining ring from the headlamp (3).
4. Remove the headlamp from the headlamp mounting bracket (2).
5. Disconnect the electrical connector (1) from the headlamp.

INSTALLATION PROCEDURE




1. Connect the electrical connector (1) to the headlamp (3).
2. Install the headlamp to the headlamp mounting bracket (2).
3. Install the retaining ring (4) to the headlamp.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the retaining ring screws (5) to the retaining ring.

Tighten
Tighten the screws to 2 N.m (18 lb in).