Ignition Lock Cylinder

This article updated with TSB 02-02-35-001.

IGNITION LOCK CYLINDER REPLACEMENT - ON VEHICLE

Removal Procedure





1. Position the steering wheel half way between the upper and lower tilt stops.
2. Remove the steering wheel. Steering Wheel
3. Roll back the shift lever seal from the upper and the lower shrouds.
4. Remove the 2 TORX screws from the lower steering column shroud.
5. Remove the lower steering column shroud.
6. Remove the steering column trim covers. Steering Column Trim Covers - Off Vehicle
7. Using a bent tip awl, insert the tip into the ignition lock cylinder access hole.





8. Turn the ignition lock cylinder to the START position.
Using the bent tip awl, push down on the ignition lock cylinder retaining pin.
9. Release the ignition lock cylinder to the RUN position.





10. Remove the ignition lock cylinder from the lock module assembly by pulling the ignition lock cylinder away from the steering column.

Installation Procedure





1. Insert the ignition lock cylinder through the upper shroud.
2. Install the ignition lock cylinder to the lock module assembly by doing the following:
2.1. Align the positioning slot and locking tab slot on the lock module assembly to the positioning tab and locking tab on the ignition lock cylinder.
2.2. Push the ignition lock cylinder into the lock module assembly until the locking tab locks against the locking tab.
3. Install the steering column trim covers.
4. Install the shift lever seal to the upper and the lower shrouds.
5. Install the steering wheel.
5. Perform the Passlock learn procedure. Theft Deterrent - Programming Components