Turn Signal & Multifunction Switch

Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle (Column Shift)





1. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle.
2. Pop the wire harness assembly (4) out of the wire harness strap (5).
3. Remove the wire harness straps (3) from the wire harness assembly (4).
4. Remove the wire harness strap (2) from the steering column support assembly (1).





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulk head connector (1).





6. Remove the 2 pan head tapping (1).
7. Remove the turn signal and multifunction switch assembly (2).

Turn Signal and Multifunction Switch Assembly - Disassemble - on Vehicle (Floor Shift)





1. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle.
2. Pop the wire harness assembly (4) out of the wire harness strap (5).
3. Remove the wire harness straps (3) from the wire harness assembly (4).
4. Remove the wire harness strap (2) from the steering column support assembly (1).





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly off of the bulk head connector (1).





6. Remove the 2 pan head tapping screws (1).
7. Remove the turn signal and multifunction switch assembly (2).

Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle (Column Shift)





Notice: Refer to Fastener Notice in Service Precautions.

Important: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.

1. Install the turn signal and multifunction switch assembly (2).
2. Install the 2 pan head tapping screws (1).
- Tighten the screws to 7 Nm (62 inch lbs.).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulk head connector (1).





4. Pop the wire harness assembly (4) into the wire harness strap (5).
5. Install the wire harness strap (2) into the steering column support assembly (1).
6. Install the wire harness straps (3) onto the wire harness assembly (4).
7. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle.

Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle (Floor Shift)





Notice: Refer to Fastener Notice in Service Precautions.

Important: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.

1. Install the turn signal and multifunction switch assembly (2).
2. Install the 2 pan head tapping screws (1).
- Tighten the screws to 7 Nm (62 inch lbs.).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulk head connector (1).





4. Pop the wire harness assembly (4) into the wire harness strap (5).
5. Install the wire harness strap (2) into the steering column tilt head assembly (1).
6. Install the wire harness straps (3) onto the wire harness assembly (4).
7. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle.