83. P3 Planetary Inspection

P3 Planetary Inspection





1. Measure the end play between P3 planetary carrier (1) and thrust washer (2) at each pinion gear (3).
2. Replace the P3 planetary carrier assembly If the end play exceeds specifications.

Pinion End Play
Maximum end play is 1.010 mm (0.0040 inch)





3. Inspect the wear of each P3 carrier assembly tooth by placing a straight edge (3) against the side of each carrier assembly tooth (2).
4. Observe the wear on the carrier assembly tooth at dimension A.
5. If detectable notching has occurred, replace the P3 planetary carrier assembly.