Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle

Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle

1. Remove the turn signal cancel cam, bearing thrust washer. Refer to Turn Signal Cancel Cam and Bearing Thrust Washer - Disassemble - Off Vehicle Turn Signal Cancel Cam and Bearing Thrust Washer - Disassemble - Off Vehicle.




2. Remove the round washer head screw (2) from the signal switch arm actuator.
3. Pry out the signal switch arm actuator (3) from the steering column housing assembly.
4. Remove the 3 binding head cross recess screws (1) from the turn signal switch assembly.




5. In order to remove the turn signal switch assembly, use the following steps:

* Remove the steering column wire harness strap.
* Remove the wiring protector.




6. Disconnect the terminal connector from the turn signal switch assembly connector.
7. Remove the terminal connector from the dimmer switch assembly.
8. Pull the turn signal switch assembly connector through the steering column, if needed.