Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle

Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle

Removal Procedure

1. Remove the upper column components. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement - On Vehicle Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement - On Vehicle.




2. Remove the round washer head screw (2).
3. Remove the switch actuator arm assembly (3).
4. Remove the pan head 6-lobed socket screws (1).




5. Remove the wire protector.




6. Pull the turn signal switch assembly connector through the column and remove the turn signal switch assembly.

Installation Procedure




1. Pull the turn signal switch assembly connector through column and onto the race and upper shaft assembly.





Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the pan head 6-lobed socket screws (1).

Tighten the screws to 3.5 Nm (31 lb in).

3. Lubricate and install the switch actuator arm assembly (3).
4. Install the round washer head screw (2).

Tighten the screw to 2.3 Nm (20 lb in).




5. Install the wire protector.
6. Install the upper column components. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement - On Vehicle Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement - On Vehicle.