Hood: Adjustments

Hood Adjustment

Important: Always perform the hood guide bumper assembly alignment before adjusting the hood.


1. Adjust the hood until the hood is level.
2. Align the feature lines of the hood and the door.
3. Ensure that there is a 19 mm (0.75 in) gap between the rear edge of the hood and the front of the door.

Adjust the hood for the following conditions:

* Alignment side to side
* Alignment fore and aft
* Correct height

Checking the Hood Bumper Assembly Alignment

1. Open the hood.
2. Obtain an assistant.
3. Stand on the running board/fuel tank.
4. Tell the assistant to lower the hood slowly.




5. Look across the vehicle from rubber hood bumper to rubber hood bumper in order to observe if the centerline of the rubber hood bumpers align to the centerline of the sheet metal hood guides.




6. If the centerline of the hood bumpers and the hood guides do not align the hood bumper assembly.

Hood Bumper Assembly Alignment

Use the following procedure in order to align the hood bumpers or in order to adjust the rear of the hood from side to side:




1. Loosen the two nuts on the hood bumpers.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Slide the bumper into the slotted holes in the bumper bracket until the following conditions occur:

* The hood is in the desired position.
* The rubber hood bumpers centerline aligns to the sheet metal hood guides centerline.
* Verify that the left hand hood bumper centerline to the right hand hood bumper centerline measures 1720 mm (67.75 in).

Tighten the hood bumper nuts to 8 Nm (71 lb in).

Hood Alignment

Adjust the hood until the hood is level. Align the feature lines of the hood and the door. Ensure that there is a 19 mm (0.075 in) gap between the edge of the hood and the front of the door. Measure the gap 25.4 mm (1 in) below the feature line.





Notice: Refer to Fastener Notice in Cautions and Notices.

1. Use the following procedure in order to adjust the hood fore and aft:

1. Tilt the hood forward.
2. Ease the hood onto a padded table.
3. Loosen the bolts holding the hinge brackets to the radiator support.
4. Slide the hood and the hinge brackets forward or rearward in order to obtain the 19 mm (0.75 in) gap.

Tighten the hood hinge to radiator support bolts to 30 Nm (22 lb ft).

2. Use the following procedure in order to adjust the height of the hood:

1. Tilt the hood forward.
2. Loosen the hood guide bracket to bumper bracket bolts.
3. Raise or lower the bumper brackets.

Tighten the hood bumper bracket bolts to 25 Nm (18 lb ft).