Ignition Switch Assembly - Assemble - Off Vehicle

Ignition Switch Assembly - Assemble - Off Vehicle





Notice: Refer to Fastener Notice in Cautions and Notices.

1. Install the dimmer and ignition switch mounting stud (4).

Tighten the dimmer and ignition switch mounting stud to 4 Nm (35 lb in).

2. Install the ignition switch assembly (1) to the ignition switch actuator assembly.
3. Install the ignition switch assembly (1) onto the dimmer and ignition switch mounting stud (4).
4. Install the washer head screw (2) into the ignition switch assembly (1).
5. Tighten the washer head screw (2) finger tight.
6. Install the hexagon nut (3) onto the dimmer and ignition switch mounting stud (4)
7. Tighten the hexagon nut (3) finger tight.




8. Move the ignition switch assembly slider (2) to the far right position.
9. Move the ignition switch assembly slider (2) detent to the left. This is the OFF-LOCK position.
10. Install a 3/32 inch drill bit into the hole on the ignition switch assembly (1) to limit travel.
11. Push against the ignition switch actuator assembly to limit all the lash.
12. Install the dimmer switch assembly. Refer to Dimmer Switch Assembly - Assemble - Off Vehicle Dimmer Switch Assembly - Assemble - Off Vehicle.