Engine Coolant Temperature Sensor Replacement (L18)

Engine Coolant Temperature Sensor Replacement (L18)

Removal Procedure




1. Drain the cooling system. Refer to Cooling System Draining and Filling Cooling System Draining and Filling.
2. Disconnect the electrical connector from the bracket.
3. Disconnect the engine coolant temperature (ECT) sensor electrical connector (3).




4. Remove the ECT sensor.

Installation Procedure





Notice: Refer to Fastener Notice in Cautions and Notices.

1. Install the ECT sensor.

Tighten the ECT sensor to 20 Nm (15 lb ft).




2. Connect the ECT sensor electrical connector (3).
3. Connect the electrical connector to the bracket.
4. Fill the cooling system. Refer to Cooling System Draining and Filling Cooling System Draining and Filling.