Steering Arm Replacement (With FH4)

Steering Arm Replacement (With FH4)

Removal Procedure

1. Disconnect the relay rod from the steering arm. Refer to Relay Rod Replacement (Without FH4) Relay Rod Replacement (Without FH4)Relay Rod Replacement (With FH4) Relay Rod Replacement (With FH4).
2. Remove the cotter pin (10).




3. Remove the nut (9).

Important: Do not use heat on components in order to remove the arms.


4. Drive the arm (1) from knuckle (6) with a suitable brass drift and hammer.

Installation procedure




1. Install new steering arm (1) with key supplied.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the nut (9).

Tighten the nut to 1238 Nm (913 lb ft).

3. Install the cotter pin (10).
4. Install the relay rod to the steering arm. Refer to Relay Rod Replacement (Without FH4) Relay Rod Replacement (Without FH4)Relay Rod Replacement (With FH4) Relay Rod Replacement (With FH4).