Transverse Rod Replacement (With GPG)

Transverse Rod Replacement (With GPG)

Removal Procedure




1. Remove the locknuts (4) and the washers (3) that connect the transverse rod (1) to the frame.




2. Remove the locknuts (4) and the washers (3) that fasten the transverse rod (1) to the axle housing (2).
3. Remove the transverse rod (1).




4. Remove the transverse rod bracket from the frame.
5. Inspect the transverse rod bushings. If the transverse rod bushings are worn or damaged, remove the bushing from the transverse rod (1).

Installation Procedure

1. Install the bushings in the transverse rod.




2. Position the transverse rod (1) in the bracket on the axle housing (2).





Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the following components:

* The transverse rod bolt (7)
* The washers (6)
* The locknuts (4) that fasten the rod to the bracket

Tighten the locknut to 508 Nm (375 lb ft) for models with GPG.

4. Install the following components:

* The reinforcement bolts
* The washers
* The locknuts that fasten the torque rod and the bracket to the frame

Tighten the rod bar pin nuts to 298 Nm (220 lb ft).