Steps 46-68

46. Remove the bracket for the battery positive cable junction block from the power steering pump mounting bracket.





47. Move the battery positive and negative cables aside.





48. Remove the nut holding the ground wire to the stud at the rear of the right cylinder head.
49. Remove the stud holding the engine wiring harness bracket to the rear of the right cylinder head.
50. Remove the nut holding the engine wiring harness bracket to the stud for the EVAP canister purge solenoid valve.





51. Remove the bolt holding the ground strap and the ground wire to the rear of the left cylinder head.
52. Move the engine wiring harness aside.
53. Remove both heater hoses from the engine and the cowl.
54. Remove the distributor cap.
55. Disconnect the fuel pipes at the rear of the engine.
56. Disconnect the hose to the EVAP purge canister solenoid valve.





57. Disconnect the power brake booster vacuum hose from the engine and the vacuum brake booster.





58. Loosen the nut holding the power steering pump rear bracket to the side of the engine.
59. Remove the nut holding the power steering pump rear bracket to the front of the engine
60. Remove the three bolts and the nut holding the power steering pump mounting bracket to the engine.
61. With the power steering pump and the A/C compressor still attached, slide the power steering pump mount bracket off of the stud and set aside.
62. Remove the water outlet.





63. Remove the EGR valve inlet pipe from the intake and exhaust. manifold.





Notice: Refer to Fastener Notice in Service Precautions.

64. Attach the J 41427 to the left front and right rear intake manifold mounting bolts, using the following procedure:
64.1. Remove the right rear lower intake manifold bolts.
64.2. Install the J 41427 marked RIGHT REAR.
64.3. Install the retaining bolts.
- Tighten the bolts to 15 Nm (11 ft. lbs.).
64.4. Remove the left front lower intake manifold bolts.
64.5. Install the J 41427 marked LEFT FRONT with the arrow pointing to the front of the engine.
64.6. Install the retaining bolts.
- Tighten the bolts to 15 Nm (11 ft. lbs.).
65. Attach a suitable lifting device to the engine lift brackets.





66. Remove the engine motor mount to frame bracket bolts.
67. Support the transmission with a suitable jack.
68. Remove the engine.