Turn Signal & Multifunction Switch - Assemble

1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.

Notice: Refer to Fastener Notice in Service Precautions.

Important: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.

2. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).
- Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





4. Reconnect the turn signal and multifunction switch assembly connector to the inflatable restraint steering wheel module coil connector.

Important: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The electronic lock module assembly wires and connector must be hanging out of the middle of the abrasion sleeve.

5. Attach the wire harness assembly (1) to the wire restraint clip (2).
6. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle.