Multifunction, Turn Signal & Hazard Switch

Removal Procedure





1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gauges and Warning Indicators.
3. Loosen the steering column bracket nuts.
4. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement- On Vehicle.
5. Disconnect the steering column bulkhead connector from the vehicle harness.





6. Disconnect the steering column bulkhead connector from the vehicle wire harness.





7. Disconnect the gray and the black connectors (2) of the switch from the column bulkhead connector.





8. Remove the wire harness straps from the steering column wire harness.
9. Remove the multifunction switch retaining screws from the switch.
10. Remove the multifunction turn signal/hazard switch.


Installation Procedure





1. Install the multifunction turn signal/hazard switch to the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the screws retaining the multifunction switch to the steering column.
- Tighten the screws to 6 Nm (53 inch lbs.).





3. Install the gray and black wiring harness connectors (1) to the column bulkhead connector.





4. Install the steering column bulkhead connector to the vehicle wire harness.
- Tighten the center screw to 6 Nm (53 inch lbs.).
5. Install the wire straps on the steering column wire harness.
6. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle.
7. Tighten the steering column bracket nuts.
- Tighten the nuts to 30 Nm (22 ft. lbs.).
8. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gauges and Warning Indicators.
9. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.