47. Rotating Clutch Housing Bushing Replacement
Rotating Clutch Housing Bushing ReplacementTools Required
^ J43778 Rotating Clutch Bushing Installer
^ J8092 Universal Driver
Removal Procedure
Notice: DO NOT score the rotating clutch housing bore when removing the clutch housing bushing.
1. Gently tap the bushing through the inside of the rotating clutch housing until the bushing becomes dislodged.
2. Remove the bushing (2) from the rotating clutch housing (1).
3. Remove any nicks or burrs with crocus cloth.
Installation Procedure
1. Position the rotating clutch housing (4) on a press so that the front of the housing is facing up.
Important: The preferred method for installing the rotating clutch housing bushing is to use the J43778 and a press. If a press is not available, use the J43778 and the J8092.
2. If the bushing will be installed without a press, install the large end of J43778 (2) onto J8092 (1).
3. Install a new bushing (3) onto J43778 (2).
4. Using J8092, press or drive the new bushing into the clutch housing.
Install the bushing flush to 0.25 mm (0.01 inch)below the rotating clutch housing surface.