80. P2 Planetary Carrier Bushing Replacement
P2 Planetary Carrier Bushing ReplacementTools Required
^ J43785 P2 Bushing Remover/Installer
^ J8092 Universal Driver
Important: The preferred method for removing/installing the P2 carrier bushing is to use J43785 and a press. If a press is not available, use J43785 and universal driver J8092.
1. Position P2 planetary carrier (3) on wooden blocks on the press with the external splines facing up.
2. If the bushing will be removed with out a press, install the short end of J43785 (2) onto J8092 (1).
3. Using J43785 (2), press or drive bushing (4) out of carrier (3).
4. Position P2 planetary carrier (4) on wooden blocks on the press with the external splines facing down.
5. If the bushing will be installed without a press, install the long end of J43785 (2) onto J3092 (1).
6. Install a new bushing (3) onto J43785 (2).
7. Using J43785 (2), press or drive the bushing into of the carrier until J43785 (2) seats.