Fog Lamp Replacement - Rear

REMOVAL PROCEDURE




1. Remove rear fog lamp retaining bolt (2) from the fog lamp bracket.
2. Disconnect the electrical connector from the rear fog lamp assembly.
3. Remove the fog lamp assembly (1) from the vehicle.

INSTALLATION PROCEDURE




1. Install the fog lamp assembly (1) to the bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the fog lamp retaining bolt (2).

Tighten
Tighten the fog lamp bolt to 25 N.m (18 lb ft).

3. Connect the electrical connector to the fog lamp assembly.
4. Inspect the fog lamp aiming.