Turn Signal & Multifunction Switch

Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle (Floor Shift)





1. Remove the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle.
2. Remove the wire harness assembly (1) from the wire harness strap (2) and the steering column.
3. Disconnect the turn signal and multifunction switch assembly connector from the inflatable restraint steering wheel module coil connector.





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





5. Remove the 2 pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
6. Remove the turn signal and multifunction switch assembly (2) from the steering column housing assembly.

Assemble

Important: The electrical contact of the turn signal and multifunction switch assembly (2) must rest on the turn signal cancel cam assembly.





1. Install the turn signal and multifunction switch assembly (2) onto the steering column housing assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).
Tighten
Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).





3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





4. Reconnect the turn signal and multifunction switch assembly connector to the inflatable restraint steering wheel module coil connector.
5. Attach the wire harness assembly (1) to the steering column wire harness strap (2).
6. Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle.