Steering Column Bracket

BRACKET REPLACEMENT - STEERING COLUMN

REMOVAL PROCEDURE

IMPORTANT: The steering column support is not serviceable.




1. Remove the instrument panel.
2. Remove the brake switch.
3. Remove the brake booster pushrod from the brake pedal. Refer to Vacuum Brake Booster Replacement in Hydraulic Brakes.
4. Remove the clutch master cylinder pushrod from the clutch pedal, if equipped.
5. Remove the following steering column support fasteners:
- The 4 flange nuts
- The 2 bolts
6. Remove the brake pedal from the steering column support.

INSTALLATION PROCEDURE




1. Install the brake pedal to the steering column support.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the steering column support bracket fasteners.

Tighten
- Tighten the nuts to 25 N.m (18 lb ft).
- Tighten the bolts to 25 N.m (18 lb ft).

3. Install the brake switch.
4. Install the brake booster pushrod to the brake pedal. Refer to Vacuum Brake Booster Replacement in Hydraulic Brakes.
5. Install the clutch master cylinder pushrod to the clutch pedal if equipped.
6. Install the instrument panel.