Rear Bumper: Service and Repair

Rear Bumper Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) in General Information.
2. Remove the brace to frame bolts.
3. Remove the bracket to frame bolts.
4. Remove the bumper from the vehicle.
5. Remove the brace to bumper nuts.




6. Remove the bracket to bumper bolts and nuts.
7. Remove the bracket from the bumper.

Installation Procedure




1. Install the bracket to the bumper.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the bracket to bumper bolts and nuts.

Tighten the bolts and nuts to 35 Nm (26 lb.ft.).

3. Install the brace to the bumper.
4. Install the brace to the bumper nuts.

Tighten the nuts to 35 Nm (26 lb.ft.).

5. Install the bumper to the vehicle.
6. Install the bracket to the frame bolts and nuts.

Tighten the bolts and nuts to 55 Nm (41 lb.ft.).

7. Install the brace to the frame bolts.

Tighten the bolts to 35 Nm (26 lb.ft.).

8. Remove the safety stands and lower the vehicle.