Headlamp Replacement
HEADLAMP ASSEMBLY OR HEADLAMP BULB REPLACEMENTREMOVAL PROCEDURE
CAUTION: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments To help avoid personal injury:
- Turn off the lamp switch and allow the bulb to cool before changing the bulb.
- Leave the lamp switch OFF until the bulb change is complete.
- Always wear eye protection when changing a halogen bulb.
- Handle the bulb only by its base. Avoid touching the glass.
- Keep dirt and moisture off the bulb.
- Properly dispose of the used bulb.
- Keep halogen bulbs out of the reach of children.
1. Turn off the headlamp switch.
2. Open the hood.
3. Remove the screw that retains the corner capsule to the composite headlamp.
4. Remove the three bolts that retain the composite headlamp.
5. Remove the headlamp.
6. Disconnect the headlamp electrical connectors.
7. Remove the headlamp bulbs.
INSTALLATION PROCEDURE
CAUTION: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:
- Turn off the lamp switch and allow the bulb to cool before changing the bulb.
- Leave the lamp switch OFF until the bulb change is complete.
- Always wear eye protection when changing a halogen bulb.
- Handle the bulb only by its base. Avoid touching the glass.
- Keep dirt and moisture off the bulb.
- Properly dispose of the used bulb.
- Keep halogen bulbs out of the reach of children.
1. Install the headlamp bulbs.
2. Connect the headlamp electrical connectors.
3. Install the headlamp assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the bolts in order to retain the composite headlamp.
Tighten
Tighten the composite headlamp bolts to 13 N.m (115 lb in).
5. Install the corner capsule.
6. Install the corner capsule screw.
Tighten
Tighten the corner capsule screw to 5 N.m (44 lb in).
7. Close the hood.