Shift Lever

Shift Lever Replacement - on Vehicle

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the lower trim cover. Refer to Steering Column Trim Covers Replacement- On Vehicle.
3. Roll the shift lever boot back until the shift lever mounting screw is exposed.
4. Remove the shift lever mounting screw.
5. Remove the shift lever wiring from the retainer clips and tie strap.
6. Disconnect the shift lever electrical connector.
7. Remove the shift lever.

Installation Procedure





1. Install the shift lever.
2. Connect the shift lever electrical connector.
3. Install the wiring on the retainer clips and new tie straps.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the shift lever mounting screw.
- Tighten the shift lever mounting screw to 22 Nm (16 ft. lbs.).
5. Roll the shift lever boot over the TORX head screw.
6. Install the lower column cover. Refer to Steering Column Trim Covers Replacement - On Vehicle.
7. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.