Steering Wheel

Steering Wheel Replacement

- Tools Required
- J 1859-A Steering Wheel Puller

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the steering wheel inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Restraint Systems.
3. Remove the horn plunger from the steering column by pressing inward to the stop and rotation the horn plunger 90 degrees.





4. Remove the steering wheel retaining nut.





5. Install the J 1859-A to the steering wheel.

Notice: When removing the steering wheel, use only the specified steering wheel puller. Do not hammer on the end of the steering column shaft. Hammering could loosen the plastic injections which maintain the steering column rigidity.

6. Remove the steering wheel using the J 1859-A.
7. Remove the J 1859-A from the steering wheel.

Installation Procedure





1. Install the steering wheel to the steering shaft.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the steering wheel retaining nut.
- Tighten the steering wheel retaining nut to 41 Nm (30 ft. lbs.).
3. Install the horn plunger to the steering column.
4. Install the steering wheel inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Restraint Systems.
5. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.