Engine Oil Pressure Sensor or Switch Replacement

TOOLS REQUIRED
J 25254-10 A Oil Pressure Sending Unit Socket

REMOVAL PROCEDURE




1. Remove the engine cover.
2. Disconnect the electrical connector.
3. Remove the engine oil pressure (EOP) sensor using J 25254-10 A.

INSTALLATION PROCEDURE




1. Install the EOP sensor.

NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.

2. Hold the EOP sensor fitting with a wrench to prevent from turning. Use J 25254-10 A in order to tighten the EOP sensor.

Tighten
Tighten the sensor to 30 N.m (22 lb ft).

3. Connect the electrical connector.
4. Install the engine cover.