Park Brake Pedal Assembly Replacement
Park Brake Pedal Assembly ReplacementRemoval Procedure
1. Install the pin into the park brake pedal.
2. Remove the release handle.
3. Remove the left side kick panel.
4. Remove the front brake cable from the pedal.
5. Remove the pedal retaining nuts.
6. Remove the pedal from the vehicle.
Installation Procedure
1. Install the pin into the NEW pedal.
2. Install the pedal to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the pedal retaining nuts.
Tighten the pedal retaining nuts to 25 Nm (18 ft. lbs.).
4. Connect the front brake cable to the pedal.
5. Install the release handle.
6. Install the left side kick panel by snapping into the pillar.
7. Remove the pin from the park brake pedal.
8. Move the pedal into the FULL up position.
9. Verify that the vehicle will hold position with the brake pedal depressed.
10. If additional adjustments need to be made, refer to Park Brake Adjustment.