Turn Signal & Multifunction Switch - Assemble

Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle





1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
2. Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.

Notice: Refer to Fastener Notice in Service Precautions.

3. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).
- Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).

Notice: Refer to Improper Routing of the Wire Harness Notice in Service Precautions.





5. Attach new wire harness straps to the wire harness assembly (1).
6. Attach the wire harness assembly (1) to the wire harness strap (2).
7. Install the upper and lower trim covers.
8. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in Restraint Systems.