Instrument Panel Module Replacement

CAUTION: Be careful when you handle a Sensing And Diagnostic Module (SDM). Do not strike or jolt the SDM. Before applying power to the SDM:
^ Remove any dirt, grease, etc. from the mounting surface
^ Position the SDM horizontally on the mounting surface
^ Point the arrow on the SDM toward the front of the vehicle
^ Tighten all of the SDM fasteners and SDM bracket fasteners to the specified torque value

Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.

REMOVAL PROCEDURE

CAUTION: Refer to SIR Caution in Service Precautions.




1. Disable the SIR system.
2. Remove the passenger knee bolster.
3. Remove the Connector Position Assurance (CPA) from the inflatable restraint IP module harness connector.
4. Disconnect the inflatable restraint IP module pigtail connector.
5. Remove the inflatable restraint IP module mounting fasteners (2).
6. Remove the inflatable restraint IP module (3) from the IP carrier (1).

INSTALLATION PROCEDURE




1. Install the inflatable restraint IP module (3) to the IP carrier (1).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the inflatable restraint IP module mounting fasteners (2).

Tighten
Tighten the fasteners to 10 Nm (89 lb in).

3. Connect the inflatable restraint IP module pigtail connector.
4. Install the Connector Position Assurance (CPA) to the inflatable restraint IP module harness connector.
5. Install the passenger knee bolster.
6. Enable the SIR system.