Park/Turn Signal Lamp Replacement (Base Vehicles)

REMOVAL PROCEDURE




1. Remove the screws (3) that retain the park/[1][2]turn signal lamp to the radiator grille.
2. Remove the park/[1][2]turn signal lamp (2) from the radiator grille.
3. Disconnect the bulb socket (1) from the park/[1][2]turn signal lamp by turning the bulb sockets in a counterclockwise direction.
4. Remove the bulb (1) from the socket.

INSTALLATION PROCEDURE




1. Connect the bulb (1) into the socket.
2. Connect the bulb socket (1) into the park/[1][2]turn signal lamp.
3. Install the park/[1][2]turn signal lamp (2) to the radiator grille (5).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the park/[1][2]turn signal lamp retaining screws (3) to the radiator grille.

Tighten
Tighten the screws to 1.5 N.m (13 lb in).